Drivers NXP Port Devices

Install Drivers for NXP FRDM-KL25ZBoard

The NXP™ FRDM-KL25Z boardhas an open standard embedded serial and debug adapter called OpenSDA.This adapter bridges the serial and debug communications between aUSB host computer and an embedded target processor.

Nxp

Download driver USB WDM Audio Device Drivers version 6.3.9600.16384. (or NXP) DSS350 Digital. Ltd DA-Port DAC.

  • Reach out to the local NXP representative with requests for more information or to port the V3 driver to legacy MCU devices. Thanks to a layered approach, the new driver simplifies the porting of the driver to new serial or CAN communication interfaces significantly.
  • Basically, at that point it lets you select which drivers you want and includes them in a drivers folder. Eclipse embedded driver nxp-microcontroller asked Jul 1 '20 at 19:17.

Before you use the NXP FRDM-KL25Z board with the host computer, install the OpenSDA USB drivers.

To install the OpenSDA USB driver:

  1. Download and Install the P&E OpenSDA USB Drivers from the site https://www.pemicro.com/opensda/.

    Make sure that you have the latest bootloader and the OpenSDA firmware on your board. To get the latest firmware, refer to the section, Get the Latest Bootloader and the Firmware.

  2. Connect a USB cable from your computer to the OpenSDAmini-B USB connector.

    The board appears as a removable storage drive with a volumelabel FRDM-KL25Z.

Drivers Nxp Port Devices Inc

The MSD Flash Programmer also includes a USB virtualserial port, which requires an .INF file for installation in Windowsplatform. The .INF file is available in the P&E OpenSDA USB Drivers(Step 1) and also on the FRDM-KL25Z removable drive.

Drivers Nxp Port Devices Bluetooth

To install the USB virtual serial port driver:

  1. Open Start menu > Control Panel >Device Manager.

  2. Go to ports and check if 'OpenSDA - CDC Serial Port'is available. The driver installation is complete if OpenSDA –CDC exists. Otherwise, you should see 'PEMicro/Freescale - CDC SerialPort' under 'other devices' as shown below.

  3. Right click on 'PEMicro/Freescale - CDC Serial Port'and select Update Driver Software.

  4. In the Update Driver Software dialog box, select Browsemy computer for driver software. The driver is availablein the P&E OpenSDA driver package that you have installed as wellas on the FRDM-KL25Z removable drive.

  5. Point to either location to locate the USB virtualserial driver.

  6. Click to complete theinstallation.

    After you install the driver, you will see the serial port forFRDM-KL25Z Board under Ports.

Comments are closed.