Drivers Segger Port Devices

-->
  1. Drivers Segger Port Devices Gigabit
  2. Drivers Segger Port Devices Lucie
  3. Drivers Segger Port Devices Usb
  4. Drivers Segger Port Devices Inc

The CE input enables the device. Signal is active low. If the signal is inactive, device is in standby mode. WE: Write Enable: The WE input controls writes to the I/O port. Commands, address and data are latched on the rising edge of the WE pulse. RE: Read Enable: The RE input is the serial data-out control. When active (low) the device outputs. For most devices, the Ports device setup class and the Serial function driver provide the functionality required to operate serial ports and COM ports. To install serial ports and COM ports using these system-supplied components, do the following.

For most devices, the Ports device setup class and the Serial function driver provide the functionality required to operate serial ports and COM ports. To install serial ports and COM ports using these system-supplied components, do the following:

Lucie

Drivers Segger Port Devices Gigabit

Devices

Drivers Segger Port Devices Lucie

  • Provide an INF file that specifies the Ports device setup class and the Serial function driver as the service for the port.

  • To configure a serial port as COM port, comply with the requirements that are defined in Configuration of COM Ports.

Drivers Segger Port Devices Usb

For more information about installing serial ports and COM ports using the Ports device setup class and the Serial function driver, see the following topics:

Drivers Segger Port Devices Inc

Devices

If you do a custom installation of a COM port, you must comply with the COM port requirements that are defined in Configuration of COM Ports.

Comments are closed.